Spring Refresh for Your Irrigation System: Get Ready for Growing Season!

Setup & How-To's Pro Schedules
, ,
1

As your garden comes back to life, it’s the perfect time to check and tune up your RainPoint smart irrigation system. Here’s a simple yet complete guide to make sure every plant gets the right amount of water this spring.

:clipboard: Spring System Checklist

Hardware Check

  • Inspect pipes and fittings for cracks or wear.

  • Clean sprinklers and drip emitters to prevent clogs.

  • Make sure the controller is securely installed and powered.

Power & Connection

  • Replace batteries (Update with fresh alkaline batteries).

  • Check Wi-Fi/gateway signal strength; reposition if needed.

  • Open the RainPoint app to confirm all devices are online.

Water Source & Pressure

  • Slowly open the main valve and check for leaks.

  • Verify water pressure is within the recommended range (typically 20–60 PSI).

  • Flush the main line for 30 seconds to clear any debris.

:gear: Key Settings to Adjust

Update Watering Schedule

  • Remove any winter or dormant settings.

  • Adjust frequency and duration based on spring temperatures and plant types.

  • Tip: Start with watering 2–3 times per week when temps are 50–60°F, and increase as it warms.

Smart Weather Features

  • Refresh your local weather source in the app.

  • Increase “Rain Delay” sensitivity for spring showers.

  • Enable “Temperature Skip” to avoid watering when it’s too cold (e.g., below 40°F).

Optimize Zones

  • Group plants by water needs (lawn, flowers, veggies, etc.).

  • Create a separate schedule for new seedlings or transplants.

  • Check each sprinkler’s coverage and adjust as needed.

:magnifying_glass_tilted_left: Pro Maintenance Tips

Recalibrate Soil Sensors

  • Insert sensors into damp soil to reset baseline.

  • Set ideal moisture ranges per plant type in the app.

Water-Saving Settings

  • Turn on “Evapotranspiration (ET) Adjustment” to adapt to spring sun and wind.

  • Set “Maximum Run Time” to prevent overwatering.

:tulip: Spring-Specific Watering Scenes

  • “Seed Start” Mode: Short, frequent watering for new seeds (e.g., 5 minutes daily).

  • “Lawn Green-Up” Plan: Deep watering after fertilizing your lawn.

  • “Bloom Care” Setting: Slightly reduce water for flowering plants to protect buds.

:tear_off_calendar: Spring Watering Schedule

Period Frequency Duration per Zone Best Time to Water
Early Spring 2–3 times/week 10–15 minutes 6–8 AM
Mid-Spring 3–4 times/week 15–20 minutes 5–7 AM
Late Spring 4–5 times/week 20–25 minutes 5–7 AM

:warning: Quick Troubleshooting

  • Some areas not getting enough water?
    Check zone valves and clean clogged sprinklers.

  • System skipping scheduled runs?
    Adjust your Rain Delay settings—they might be too sensitive.

  • Device offline in the app?
    Restart the controller and check your Wi-Fi. Re-pair if needed.

:memo: Share Your Spring Prep Tips!

  • What irrigation settings do you always change in spring?

  • Have you noticed certain plants need special care this season?

  • Got a RainPoint pro tip for spring?

Share your experience and help fellow gardeners thrive this growing season!

An hour of tuning now means a healthier, happier garden all season long.